Electronic Enhancements

306 Choteau Street # 2

Shelby, MT 59474

(406) 424-8796

Project # 8864

Home Based Computer Network Install

The Completed Enclosure 

This Control Center is located in the attic of the 1st floor there are additional cable runs that run to the 2nd floor attic.

Click the images to see an enlarged view
Here you can see the overall size of the enclosure  at over 7 feet tall and 3 feet wide and 1 foot deep. There also is an enclosure to the left of the same size forming a "L" shape around the corner.  
Top Left: T1 inbound decoder Right: Add on sub electrical panel with independent circuit breakers for each work station as well as independent breakers for the switching equipment.

Left :Smoke Detector,

Left: Double Stack 12 port Patch Panels  Right: Full Phase Power filter and conditioner the entire Sub Panel has Clean Spike Free Power.

Left Linksys 24 Port 100 Base Switch  Right: Power Pack for Linksys.

Here is the add-on A/C duct which feeds the server closet be hide this wall.
The red Block Left is the termination point point for the phone system that is in the adjacent enclosure. Left: Cisco Router which is providing the T1 Internet connection for all work stations. Right: Is and additional APC power filter which helps suppress noise in the phone system.

 
Here on the Bottom we have (Left) Battery Box Which powers phone system during power outages. (Right Upper) Main phone system switch. (below) A cooling fan which pulls cold air from server closet as this attic easily reaches 140 Degrees in the summer.   
Here is a shot of a Video Board we made up to remove this equipment from the other location where it had been mixed in with the networking equipment.